Skip to content

Anker

Soundcore Liberty 3 Pro

Highly supported
Highly supportedAll features or at least all major features are supported, which is enough to cover almost all cases.
No-vendor pairInitial pair can be done in Gadgetbridge without needing the proprietary vendor app.

Support for this gadget was added in pull request #3753.

Working features

  • Connection
  • Firmware version and serial number
  • Display battery life when sent by earbuds
  • Set noise cancelling and transparency
  • Update noise cancelling / transparency setting in Gadgetbridge when changed on the earbuds
  • Set the behavior of touch actions

Missing features

  • Hear-Id (calibration of ANC for your ears)
  • Equalizer
  • Actively requesting the battery-life of the earbuds, so it may get out-of-date

Soundcore AeroFit 2

Partially supported
Partially supportedMissing important features, you might be required using vendor app at some point to manage the gadget.
No-vendor pairInitial pair can be done in Gadgetbridge without needing the proprietary vendor app.

Support for this gadget was added in pull request #5297.

Working features

  • Connection
  • Firmware version and serial number
  • Display battery life when sent by earbuds
  • Settings:
    • Toggle "Gaming Mode"
    • Toggle "Touch Lock" (disable all touch events)
    • Toggle "Touch Tone" (sound when touch is detected)
    • Toggle "Low Battery Tone"
    • Set Auto Power-Off Timer
  • Find Device

Missing features

  • Read settings from the device
  • Equalizer
  • Tap Control
  • Switch between Multipoint and LDAC
  • Volume Balance (left to right volume difference)
  • Find Device only "on for both" or "off for both", not "only left" or "only right", this is currently a GB limitation
  • Firmware Updates

Soundcore Liberty 4 NC

Highly supported
Highly supportedAll features or at least all major features are supported, which is enough to cover almost all cases.
No-vendor pairInitial pair can be done in Gadgetbridge without needing the proprietary vendor app.

Support for this gadget was added in pull request #4050.

The details provided for Soundcore Liberty 3 Pro also apply to these headphones.

Soundcore Q30

Mostly supported
Mostly supportedMissing a few features, but it should be enough to cover essential daily tasks.
No-vendor pairInitial pair can be done in Gadgetbridge without needing the proprietary vendor app.

Support for this gadget was added in pull request #4316.

Working features

  • Reading and writing ANC Settings
  • Reading Battery at Connection in 20% Steps

What is not supported:

  • Battery percentage updates while connected
  • Equalizer (protocol is implemented, but no preference yet)